- This unique tool connects at the fuse panel and becomes in series with the test circuit
- A system of audible beeps helps you find the problem and permit hands-free troubleshooting
- Gives you continuous re-set/re-power capability, a real-time saver
- While you push, pull, tug, and grab wires, Short Buddy is always watching the current level
- If your tug causes the dead short again, Short Buddy opens the circuit for 10 seconds, then re-applies power to the circuit
- Re-powering the circuit can also be done manually
- If the circuit current changes by more than approximately .3 Amps, you'll hear an audible beep
- If you pull on the ""problem"" wire or connector, you'll hear the beep
- Settable Amp levels of 10, 15, 20, 25, and 30 Amps
- Helps with locating shorts to ground, intermittent shorts, and intermittent caused by loose connections